🧭 Steps to Use

1. 🖥️ Turn on the monitor and power up the Raspberry Pi.

2. 🪟 Log in to the desktop.

   <aside> 💡

   Username: pi

   Password: raspberry

   </aside>

3. 🧑‍💻 Open the Terminal (click the black terminal icon on the top bar).

4. ⌨️ Type the command below and press Enter:

   guvcview
   

5. 🎥 Wait a few seconds — the microscope feed will appear on the screen.

6. 🔦 Adjust the focus by twisting the silver rubber area on the microscope.

7. 💡 Adjust brightness using the control wheel on the USB cable.

8. 🧍‍♂️ When finished, close the guvcview window and unplug the microscope.

Good luck soldering!